Publish Time: 2023-08-10 Origin: Site
Concrete pump units are equipped with a special concrete pump remote control, which is very easy to use. The buttons on the remote control are similar to those on the electrical box and are equipped with a manual. The effective distance of the remote control is 50 metres, the signal is stable and penetrating, so you can use it without fear of interference.
What should I pay attention to before using the concrete pump remote control?
How to use the concrete pump remote control?
How do we maintain the concrete pump remote control?
1、The first time you use the pump remote control, you need to charge the special remote control battery pack in the charger for more than fourteen hours to activate the battery.
2、Install the battery into the remote control, pay attention to the front and back side of the battery when installing.
3、Check that the external antenna on the concrete pump remote control and the suction cup antenna on the receiver are in place.
4、When the concrete pump remote control receiver is powered on, the yellow and red lights above it are always on, which means the receiving system is powered on normally.
Concrete pump remote control open the transmitter system key switch (and at the same time dial up the red emergency stop button on the transmitter system), the transmitter system on the light will begin to flash rapidly (at this time the system is in sweeping frequency), a few seconds later, the light will become a rhythmic flashing, at this time the receiving system on the original light a yellow and a red, into a yellow and a green, (if At this time you are at the receiving system side, you can hear the closing sound of the relay inside the receiving system), at this time the remote control system work start, when you press the electric siren button on the transmitting system, you can hear the electric siren sound on the car body, indicating that the receiving system is controlled.
The different toggle switches on the concrete pump remote control allow for different functions, it is through these switches that the operator controls the pump truck boom and realises its different movements.
When controlling the movement of the concrete pump remote controlde boom, it is important to push the toggle switch with even force, and not to push it all the way down at once, as this may cause the boom to vibrate violently. At the same time, when the toggle switch is pushed to its limit, the boom speed controlled by it is at its maximum speed of expansion or retraction.
When the light on the concrete pump remote control transmitter changes from green to red, the batteries are low and need to be recharged. Generally the remote control is equipped with two batteries, one for when it is working and the other can be charged via the car charger as a backup.
Nanjing Xiading electronic technology Co.,Ltd pursue the development concept of safety, reliability and efficiency, and continue to innovate and introduce more new products to meet more customer requirements. It is believed that in the future, LCC brand remote controls will be favored by more consumers.