Publish Time: 2023-08-17 Origin: Site
It is important to ensure that the pump remote control system works properly. Today Dawei will talk about the use of concrete pump remote control and routine maintenance work.
How to deal with a malfunctioning concrete pump remote control?
What issues should I be aware of when using the concrete pump remote control?
What is the routine maintenance and servicing of the concrete pump remote control?
If the remote control of a concrete pump fails to work on the construction site, there are many reasons, such as the remote control battery running out of power, the "remote control, this machine" switch on the electrical control box panel being operated by mistake; the emergency stop switch being pressed unintentionally, etc. After ruling out the above reasons, for the remote control itself, you can switch the pump truck to the "driving" state, turn off the engine, and then restart. If it doesn't work once, then start it twice, three times or even more. Generally speaking, after several times, the concrete pump remote control can continue to operate.
The concrete pump remote control has an IP65 protection class for both the receiver and the remote control. When in use, the transmitter system is operated manually, so to protect the transmitter system during the rainy season, avoid getting it wet too much and store it properly dried afterwards.
The suction cup antenna on the receiving system of the concrete pump remote control should not be set down too often, especially in the rainy season, because the receiving system is outside, if the antenna is set down when the pump is parked, the receiving system antenna jack is exposed, when it rains, this antenna jack is prone to water accumulation, when using, if the water inside is not dried, it will seriously affect the The effect of receiving signal.
1、After the pump has finished working, the concrete pump remote control should be cleared of cement slurry and debris on the surface to keep it clean and tidy, and the battery should be removed and fully charged for the next use. The battery should be placed in a dry and ventilated environment, not in the cab, to avoid the risk of explosion due to high temperature in summer.
2、Check regularly whether the rocker protection sleeve of the concrete pump remote control is cracked, if found to be cracked, replace it in time to avoid mud and water entering and causing internal short circuit, thus damaging the system main board.
3、When cleaning the body of the pump truck, it is strictly forbidden to flush the receiving system with a high-pressure water gun! A wet cloth can be used to scrub.
4、The concrete pump remote control battery should be charged when the red light is flashing, and it is strictly forbidden to charge at high temperature (too high ambient temperature will seriously affect the charging effect).
After reading, do you have a deeper understanding of concrete pump remote control? For further information, please contact Nanjing Xiading electronic technology Co.,Ltd. They will be very pleased to help you!