Views: 0 Author: Site Editor Publish Time: 2023-07-11 Origin: Site
The remote control of concrete pumps is achieved by digitally encoding and encrypting the operating commands and transmitting them via radio to an industrial controller, which then converts them and restores the control commands to the concrete pump.
What are the system components of a concrete pump remote control?
What is the correct way to use the concrete pump remote control?
What are the performance advantages of the concrete pump remote control?
The system of concrete pump remote control consists of a transmitting system and a receiving system. The transmitting system is the remote control in the hands of the pump operator, the control signal is sent out through an external transmitting antenna, while the receiving system is usually installed in the cab and receives the signal from the transmitter through a suction cup antenna, and through modulation and demodulation, reads out the commands sent by the transmitter and controls the boom by The multi-way valve controls the operation of each section of the boom.
The wireless remote control of the concrete pump remote control is controlled within a distance of 200 metres, within which the remote control system is able to work properly, beyond this distance, it may lead to a loss of signal and thus to the remote control not working.
In general, the suction cup antenna can be placed in the cab of the concrete pump remote control can also work normally, when the control distance increases, in order to prevent the remote control from dropping the frequency, you can put the suction cup antenna on top of the cab of the vehicle to improve the reception rate of the signal.
If the construction area encounters a fixed band of interference (e.g. in TV towers, radio transmission towers, military bases and other high-power wireless transmitters), the remote control system may not work, how to change the frequency point can not be used. At this time; the concrete pump remote control can be wired (the wired control of the HBC remote control system is a bus control method, which can only solve the inability of the system to work due to wireless interference), the system is equipped with a 30m wired cable to connect the transmitting system to the receiving system as required. Note that the two connectors are not the same and must be rotated into place after insertion. When operating the concrete pump remote control, care must be taken that the control cable is not pulled too tightly and that the cable is smashed during construction.
All operations of the concrete pump remote control are completely protected from strong external electromagnetic fields, with sensitive, reliable, inching and fine-tuning movements, and an industrial grade wireless controller with good shielding at both the transmitter and receiver ends to ensure no loss of control or delay.
Nanjing Xiading electronic technology Co.,Ltd, the pioneer of concrete pump remote control producing company in China, knows that every application is special. You can go and get more information about them.
